The following are instructions for installing the various software
files in the download software list.

1. File Descriptions
DOS LibraryController x.xx.zip - this is the latest firmware for DOS
   based Library Controllers.  Install by unzipping the folder and
   copying over a duplicate of the controller formware floppy.
DSICTL Setup.exe - this is the latest firmware for the Windows XP based
   Library Controller.  Copy this file to a CD or USB drive.  Insert the
   Cd or USB drive into the Library Controller and run the .exe program.
TapeManager Release x.xxx.CON - this is the full TapeManager release in
   an MCP container file.  (see section 3)
TapeManager Release x.xxx.ZIP - this is the full TapeManager release in
   an MCP container file that has also been zipped. Unzip this file to
   the MCP container file.  (see section 3)
TAPEMANAGER.ISO - this is the full TapeManager release in a CD image
   format.  (see section 2)
TAPEMANAGERDOCS.ISO - this is the TapeManager manuals in a CD image.
   NOTE: these manuals are also contained in the full TapeManager
   release files above.

2. Installing TapeManager ISO image
   A. After downloading the ISO image, burn to a CD.  Since this is
      an MCP CD image not all burning programs will work.  For Windows
      systems Nero has been shown to burn correctly while Roxio has
      not produced usable CDs.  Other software that you might use is
      ImgBurn (http://www.imgburn.com/) (Windows)
      InfraRecorder (http://infrarecorder.sourceforge.net/) (Windows)
      K3b (http://k3b.plainblack.com/) (Linux - KDE)
   B. Load the burned CD into the MCP CD drive on the host to install
   C. If this is a new install, copy all files from the CD to the usercode and
      family where TapeManager is to be installed (COPY = AS (<UC>)= FROM
      TAPEMANAGER(CD) TO <TM family>(PACK)).
      RUN SYSTEM/TAPEMANAGER/INSTALL followed by SEND TM START
      See the TapeManager Operations Guide for additional installation
      information.
   D. For pre-existing installations, 1) Backup the TapeManager system
      (TM DB BACKUP TO DISK), then 2) TM INSTALL ALL

3. Installing TapeManager from MCP container (CON)
   A. If you choose the smaller PKZip archive, unzip the container file
       with your zip utility.
   B. Upload the container to a share on your MCP host.  If you have an installed
      TapeManager on that machine of release 5.065 or later, there will be a share
      called "TAPEMANAGER" which maps to the TAPEMANAGER directory of your
      TapeManager install family (and usercode, if the install included a
      usercode).
   C. If this is a new install, unwrap the container file (UNWRAP *= AS (<UC>)=
      OUTOF “TAPEMANAGER.CON” TO <TM family>(PACK,RESTRICTED=FALSE)).
      RUN SYSTEM/TAPEMANAGER/INSTALL followed by SEND TM START
      See the TapeManager Operations Guide for additional installation
      information.
   D. For pre-existing installations, 1) Backup the TapeManager system
      (TM DB BACKUP TO DISK), then 2) TM INSTALL ALL IN “TAPEMANAGER.CON”

These are simplified instructions meant for experienced users.  If you need
additional information please review the installation instructions found in the
TapeManager Operations Guide, the Quick Start for New Users, and the Quick Start
for Current Users documents.